Cecilware CH75N Spezifikationen PDF herunterladen (Seite 10)

SINGLE TIMER

L205A

DUAL TIMER

L214A

SOLID-STATE TIMER ADJUSTMENT:

A factory pre-set electronic solid-state timer controls the volume of water for each

brew cycle. If more or less water is desired, follow these instructions:

Turn knob of timer clockwise to increase volume of water or counterclockwise to decrease it. Run through a complete

brew cycle after each adjustment. Since timer cannot be readjusted in mid-cycle, simply push cycle stop switch at bottom

right of side box if water gets too high. If maximum setting of timer fails to deliver enough water, check water pump and

spray head and follow instructions under maintenance.

MECHANICAL TIMER ADJUSTMENT (ALL CL's & CH's): The factory pre-set mechanical timer can be adjusted for more

or less water by following these instructions:

Remove timer knob and loosen lock nut holding stop pin. To increase volume of water, rotate stop pin clockwise. To

decrease, rotate counterclockwise. Tighten lock nut and replace knob.

MANUAL TIMER

L154A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Keine Kommentare

Cecilware CH75N Spezifikationen Seite 10